Atlas Xas 185 jd7 won't stay on

by Robert
(Texas)

I have a atlas air compressor Xas 185 jd7 that starts up but once I let go of the crank position and it goes in to the run position it turns off won't stay on ?

Click here to post comments

Add your own question or comment. It's easy to do. How? Simply click here to return to Atlas Copco Compressor Issues.

Atlas Xas 185 jd7 won't stay on

by Cesar
(Paterson N.J. U.S.A.)

Atlas Xas 185 jd7 won't stay on

It cut off right after I let the main switch go back

Comments for Atlas Xas 185 jd7 won't stay on

Click here to add your own comments

Oct 29, 2016
 atlas xas wont stay running
by: gerry

i was reading this and i have the same issue. so i bypassed the temp switch and it runs about 60 seconds now then it dies. it will crank right back up and do the same thing again. thanks
Mar 03, 2015
 Compressor Oil Temp Switch Under Compressor Pump
by: Gary Pearson

Your compressor oil temperature switch is bad. Take the two wires off and put them together and engine should start. Order another switch you do not want to run it long without it connected in case the compressor oil is getting too hot.

www.sand-blasters.net
Feb 27, 2015
 start-up - not
by: Doug in s.d.ca

Maybe idle control valve stuck?

A decent diesel mechanic should be able to help you.

Click here to add your own comments

Add your own question or comment. It's easy to do. How? Simply click here to return to Atlas Copco Compressor Issues.

Atlas Copco XAS 185 shuts down

I have an Atlas Copco XAS 185 with John Deere engine. when under load it shuts down. I've had fuel and air filters changed, pressure washed the radiator. our dealer can't figure it out.

Comments for Atlas Copco XAS 185 shuts down

Click here to add your own comments

Apr 16, 2018
 185 uns until normal operating temp then shuts off
by: Anonymous

mine does the same and is the same atlas copco 49 hp john deere engine and it will run for a little bit until it reaches operating temp and is under a load then it shuts itself down.it will usually crank right back up once its sat for a minute.

Click here to add your own comments

Add your own question or comment. It's easy to do. How? Simply click here to return to Atlas Copco Compressor Issues.