parts info for 51-A17-60v 5hp 200psi 2 stage serial G1910587

by Holm Bursum
(hbursum@socorrobanking.com)

51-A17-60v 5hp 200psi 2stage serial G1910587 230volt single phase


what oil for compressor and what air filter for compressor? Where do I get?

Comments for parts info for 51-A17-60v 5hp 200psi 2 stage serial G1910587

Click here to add your own comments

Jan 05, 2015
Parts
by: Doug in s.d.ca

In the case of your machine, you go to your local distributor.

Click here to add your own comments

Add your own question or comment. It's easy to do. How? Simply click here to return to Sanborn Compressor Issues.

Source for a replacement pressure switch cover

by Aaron Reynolds
(United States)

I broke my cover on my Sanborn compressor pressure regulator, it still works fine. But I cannot find a replacement cover anywhere! Part number for the switch 034-0094. Thank you

Comments for Source for a replacement pressure switch cover

Click here to add your own comments

Feb 21, 2015
Sorry
by: Doug in s.d.ca

I don't think you'll find one.

I have seen some separate covers, but not for this. luck

Some sources say $125, others say <$22.

Either figure out an alternative cover, or maybe buy one of the cheap ones and use the cover off that.

Good luck.

Feb 21, 2015
Pressure switch cover
by: Bill

Or, replace the switch. Probably a less expensive option.

B.

Feb 21, 2015
cover
by: khameleon koatings

take it to a 3d printer guy in your area or on line that has good ratings/testimonials.... prolly should be able to replicate for under 50$...just a thought.

otherwise i would check ebay.


Click here to add your own comments

Add your own question or comment. It's easy to do. How? Simply click here to return to Sanborn Compressor Issues.

Need gasket set that will fit 21-0145

by art elliott
(independence ky)

1994 black max 5hp-2 stage 021-0145 head gasket set needed

gasket set that will fit this pump.

Comments for Need gasket set that will fit 21-0145

Click here to add your own comments

Mar 15, 2015
Gasket
by: Bill

Making your own gaskets is covered on this site.

As Doug says, when parts are no longer available, you sometimes have to make your own.

Make sure you use High-Heat gasket material, typically available from auto parts stores.

B.

Mar 15, 2015
gasket
by: Doug in s.d.ca

Good luck.

You will likely need to fashion your own...

Use auto head gasket material.

Click here to add your own comments

Add your own question or comment. It's easy to do. How? Simply click here to return to Sanborn Compressor Issues.

Where to get 10" flywheel for my Sanborn Magna Force

by Sam
(Fresno, CA)

Sanborn 3hp 9.0 scfm @ 40 psi magna force. I can not find a model number anywhere on the tank. on the pump it has the numbers 044-0018. its an upright around 20 gallon tank.

Comments for Where to get 10" flywheel for my Sanborn Magna Force

Click here to add your own comments

Feb 13, 2015
Sheave?
by: Doug in s.d.ca

For the compressor?

You can google for sheaves or v belt pulley.

At least Grainger and McMaster-Carr have what appear to be in the ballpark.

You need to know the shaft diameter.

Lots of choices, so be careful what you order.

Have fun and good luck.

Click here to add your own comments

Add your own question or comment. It's easy to do. How? Simply click here to return to Sanborn Compressor Issues.