Make Your Own
       Compressor Manifold



When they break, they are impossible to fix. When a part on them fails, you need to buy the whole manifold, and sometimes finding one is impossible even if you can ignore the cost. Here's how to Make Your Own Compressor Manifold, then.

This is a self-help forum for folks that have a broken or damaged compressor manifold and what to know how to make your own compressor manifold. After reading the page, if you have a question about building a manifold, you can ask it using the link to the appropriate forum at the end of this page.

By compressor manifold I am talking about the part, typically cast, that connects the compressor tank to the discharge coupling on the compressor. In that manifold the compressor regulator is typically found. Or, another compressor manifold may have many components, including the pressure switch, the PRV, discharge coupler and gauges attached to it.

The thing is, components on the manifold will fail or the manifold itself may fracture. When it does, do you have to replace the whole compressor manifold to replace one part? That is wasteful and possibly unecessary. The solution is to make your own compressor manifold!

Make your own compressor manifold - compressor manifold
Comprehensive and expensive compressor manifold. Make your own compressor manifold instead of buying a new one.

The idea is to use relatively easy to obtain parts, from plumbing houses to higher quality hardware stores, or acquiring the fittings on line, to create a manifold that works the same way as the original.

No, when you make your own compressor manifold it will not look the same, and you may even have to permanently remove part of a compressor covering to install the new manifold. That being the case, your choice is a pretty compressor that doesn't work, or one that works and doesn't look new. Your choice!

It will be necessary to determine the thread and female port sizes of the existing manifold. They may either be metric or NPT. Visit the Compressed Air Fittings page on this site for information about thread sizes if the existing manifold sizes are not known.

Make Your Own Compressor Manifold


The next step will be to acquire a selection of fairly common brass fittings.

Select an assortment of fittings.

Make your own compressor manifold - brass-fittings
A selection of brass fittings used to make your own compressor manifold. Images: grainger.com

Use these fittings to emulate the size, shape and function of the existing compressor manifold.

Make your own compressor manifold - brass-fittings assembly

As long as you recreate the same function of the old manifold, you can change the shape and orientation of the ports and locations of ports on the new to suit your own preference. Perhaps you want two discharge couplers, for example? Perhaps the PRV is in the way where presently installed?

Or more frequently, interference between one part or another on the manifold and the compressor makes removing and replacing it difficult.

If that is the case, add a union or two to your new manifold. This will enable faster and easier disassembly of the manfold without having to turn parts that might interfere with the compressor.

Make your own compressor manifold - brass-union
Brass unions will make dis- and reassembly of your manifold quick and easy.

Brass fittings are easily obtained on line or at good stores, are relatively low cost, and with a bit of thought can be used to make your own compressor manifold for a fraction of what a new OEM version would cost.

I do not know what the compressor manifold on every air compressor looks like. I do know, having done so myself, that you can use standard, off the shelf, brass fittings like those shown to recreate virtually any compressor manifold.

In future then, when the next component fails and needs to be replaced, doing so is relatively easy. You didn't simply buy an expensive compressor manifold off the shelf, but took the time to build your own.

To ensure that your home-built compressor manifold does not leak, I recommend the use of a paste type thread sealant on all connections.

Got a question about how to make your own compressor manifold? Here is the fittings forum on this site.