Except, that you know for sure your air compressor will run as it just did that. But now, that the pressure in the tank has reached cut out and the air compressor stopped, the compressor will not re-start when air is used.
Since the compressor was just running, you can typically pass on checking the power supply. The compressor is trying to re-start, which means that power is still getting to the motor circuit and if it was running before and the compressor tank pressure reached cut out and the compressor stopped normally, likely the power supply is OK.
Compressor motors often have a thermal switch in them which trips open and stops the power to the compressor motor if it gets too hot. If you've been abusing your compressor a bit in terms of how long you've had it running, see the page on this site about duty cycle for some tips.
One of the easiest is to determine if the compressor unloader is working. I won't go into details about what it is and does here, as it's covered in great detail on the Unloader Valve page on this site. Check that out if you don't know what the unloader valve is. Suffice to say that if the unloader isn't working your compressor may not restart, though it wants to.
If you pull the power cord and open the tank drain and let the tank empty completely, you are emulating what the unloader valve does. Once the tank is empty, make sure to close the drain and plug the compressor back in.
If it starts easily now, then you can be pretty sure that the compressor unloader valve isn't working properly, and you need to correct that. Again, see the Unloader Valve page for details.
If the start cap is weak, or failing, though it tries to, your air compressor motor may not re-start, even though it had been working fine just a short time before.
Checking the start capacitor requires a bit (OK, a lot) of fiddly work, including removing it from the motor side without shocking yourself, and using a multi-meter to check it. Lots of info on this site about how to do that. So check out those pages too.
Though the form below was added to allow folks to ask questions about why their air compressor won't start, no reason why you can't use it if your air compressor will not re-start, too.
Please FIRST read all the links on the troubleshooting page. Likely your compressor problem is already addressed on many pages on this site. Please read the questions and answers on this page too. If a question has already been asked and answered on this site then the same question cannot be responded to again.
Your air compressor still not re-starting? No idea why? Then send in your question and tell us what you have already checked, will you?
And, if you've got a suggestion about solving any of the other "compressor will not start or re-start" problems, please comment on that post to help someone else. If you wish to add photos, please start a new thread, uploade up to four pix, and ask me to move the photos to a certain posting, and II'll be happy to do so.
Read postings at the bottom of the page to see if it's already covered. If not, tell us about your problem.
Click below to see the problems others have had when their compressor will not start.
Compressor will not cut back in when pressure is low
hi have200 liter 3hp gaa belt driven compressor i have fitted a new presure switch and capacitor presure builds fine but will not cut back in when it …