Compair Holman Zitair 125 - thermal cut out switch or switches?

by Michael
(Devon England)

Hi Bill

I have the above compressor which I use to drive a lateral cutter which re opens connections in drains after they have been lined.

The compressor has run this tool with no problems until recently.

Now I can use the compressor and lateral cutter for around 20 mins then it switches itself off.
Wait 10 - 20 mins then I can re start it and use again for around the same amount of time and it will cut out again.

My question is does this compressor have a thermal cut out switch or switches that is causing this, if so where are they located and which one is most likely to be at fault.

I have these numbers from compressor

SCN B1374A PC002592
Cool technology Ltd
R34560-22
132310293

Any advice would be greatfuly recieved.

Kind Regards
Michael

______________________
Bill says...

Michael, the "cool technology" reference is to the manufacturers of the compressor tank, www.pressure-vessels.co.uk/

And yes, it sure sounds as though your compressor is shutting down by an overload switch tripping.

We will have to rely on someone that is using or has worked on a Compair Holman Zitair 125 compressor for help here, Michael.

Cheers,

Bill