What is the head bolt torque specs for a CRAFTSMAN...

by Jack
(Warren, PA, Warren)

What is the head bolt torque specs for a CRAFTSMAN model 919.167801 oil lubricated two stage air compressor?I need to replace the valve plates.


_____________________
Bill says...

Well Jack, an extensive review of this air compressor catalogue shows the warning: "Head Bolts - Check the torques of the head bolts after the first five hours of operation."

The manual goes on to say "Air compressor Head Bolts - Torquing
The air compressor pump head bolts
should be kept properly torqued.
Check the torques of the head bolts
after the first five hours of operation.
Retighten if necessary. See Parts
manual for torque specifications."

I hope someone else has this info, Jack. Cause, I sure could not find it.

Sorry,

Bill





Comments for What is the head bolt torque specs for a CRAFTSMAN...

Click here to add your own comments

Jun 26, 2013
Torque
by: Anonymous

I thought torque values were in inch pounds or foot pounds (for those in the English system). When you refer to 25-30 psi, how is that converted?

Thanks.

Apr 05, 2012
Torque specs
by: pcbeachrat

I rebuild/repair/build sandblasters and air compressors and the unit you are wondering about is A craftsman 2 stage air compressor.The head bolt torque on them is 25 to 30 psi.30 psi at the most.

When you tighten these head bolts use a criss cross pattern,and to prevent the head from warping or air leaks inbetween the gasket and head,first torque all bolts,as mentioned in a criss cross pattern but only tighten them all partially first.In other words torque them all at 15 psi first(in the criss cross pattern) and once all are at 15 psi then retorque them again another 15 psi which will make the torque wrench still read at 30 psi total.

This method keeps you from tightening one bolt to the total 30 psi and the edge of the head crimping down all the way and then can cause the head to distort/warp on the next bolt if you then tighten it all the way to 30 at one time.do half torque first on all bolts,then the last half in the same pattern as before,criss cross.I also recheck ALL MY HEAD BOLTS about every 5 to 10 hours of use.I went through 4 BRAND NEW PUMPS FROM THE FACTORY once like this,of course the company replaced them free but i lost alot of money inbetween shipping times and down time over it,but I found every pump had head bolts improperly torqued(all being way low) before i figured out what was going on with these pumps.I now when I install a pump on a customers compressor,automatically check the torque on all applicaple bolts on the unit.Anyway...25 to 30 psi on a craftsman 2 stage compressor.....Good luck

_________________
And thank you!

B.

Click here to add your own comments

Add your own question or comment. It's easy to do. How? Simply click here to return to Craftsman Compressor Issues.

installing new compression ring - preheat it or soak it?


(Maryland)

I got a new compression ring for my Craftsman 919.167310 oil-free compressor. How do you get it to fit in the cylinder? Does it need to be soaked in hot water or something?

Comments for installing new compression ring - preheat it or soak it?

Click here to add your own comments

Jul 01, 2016
compression ring
by: Anonymous

you got the wrong compression ring. compare the old to the new. that just happened to me just now and sears is sending me the correct one. the ring send me was flat and not cupped around the edges.
gerry

Click here to add your own comments

Add your own question or comment. It's easy to do. How? Simply click here to return to Craftsman Compressor Issues.